Skip to content
Raha home
All guides

Router setup guide

Your Raha DNS addresses are on the Setup page of your dashboard: Raha picks the servers nearest you.

  1. In a browser, open your router's page (usually 192.168.1.1 or 192.168.0.1) and sign in. The password is often on a label under the router.

  2. Find the DNS settings: under Internet (WAN), or under LAN / DHCP so every device on the network gets them.

  3. Set the primary and secondary DNS servers to:

    • Raha DNS 1
    • Raha DNS 2
  4. If the router has IPv6 DNS settings, set them to:

    • Raha IPv6 DNS 1
    • Raha IPv6 DNS 2
  5. Save, then restart the router (or reconnect your devices) so they pick up the new servers.

  6. On a MikroTik router, you can run this in Terminal instead:

    /ip dns set servers=<DNS 1>,<DNS 2>
    /ip dhcp-server network set [find] dns-server=<DNS 1>,<DNS 2>

Still not using Raha after this? Turn off Secure DNS (DNS over HTTPS) in your browser and pause VPN apps: both send lookups past Raha. Then check again.

Then link your network, so Raha knows which profile to use.